Azbil C35 Series

5-60
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
Operation type Set value of
operation
type
Direct action

shows that the ON/OFF is changed at
this value.
 shows that the ON/OFF is changed at a
point that "1U" is added to this value.
Reverse action

shows that the ON/OFF is changed at
this value.
 shows that the ON/OFF is changed at a
point that "1U" is added to this value.
Deviation high/
low limit
(Final SP reference)
9
Main setting Sub-setting
PV
SP
ON
HYS
ON
HYS
Same as the direct action of the deviation
high/low limit when the SP ramp is not used.
The difference is that the SP ramp does not
use the current SP, but it uses the final SP.
ON
HYS
HYS
Main setting Sub-setting
PV
SP
Same as the reverse action of the deviation
high/low limit when the SP ramp is not used.
The difference is that the SP ramp does not
use the current SP, but it uses the final SP.
SP high limit 10
ONHYS
Main setting
SP
ON
HYS
Main setting
SP
SP low limit 11
Main setting
SP
ON
HYS
Main setting
SP
ONHYS
SP high/low limit 12
Main setting (*1) Sub-setting (*
1)
SP
ON
HYS
ONHYS
Main setting (*1) Sub-setting (*1)
SP
ONHYS
HYS
MV high limit 13
ONHYS
Main setting
MV
ON
HYS
Main setting
MV
MV low limit 14
Main setting
MV
ON
HYS
Main setting
MV
ONHYS
MV high/low limit 15
Main setting (*1) Sub-setting (*
1)
MV
ON HYS ONHYS
ONHYS HYS
Main setting (*1) Sub-setting (*1)
MV
Heater 1 burnout/
Over-current(*2)
16
Main setting (*1) Sub-setting (*
1)
CT1 at output ON.
ON HYS ONHYS
OFF before measuring the CT1 current value
CT1 at output ON.
ONHYS
HYS
Main setting (*1) Sub-setting (*1)
OFF before measuring the CT1 current value
Heater 1
short-circuit(*2)
17
ONHYS
Main setting
CT1 at output OFF.
OFF before measuring the CT1 current value
ON
HYS
Main setting
CT1 at output OFF.
OFF before measuring the CT1 current value
Heater 2 burnout/
Over-current(*2)
18
Main setting (*1) Sub-setting (*
1)
CT2 at output ON.
ON HYS ONHYS
OFF before measuring the CT2 current value
CT2 at output ON.
ONHYS
HYS
Main setting (*1) Sub-setting (*1)
OFF before measuring the CT2 current value
Heater 2
short-circuit(*2)
19
ONHYS
Main setting
CT2 at output OFF.
OFF before measuring the CT2 current value
ON
HYS
Main setting
CT2 at output OFF.
OFF before measuring the CT2 current value