Example 1: Figure 29 shows the Main Menu. The selection arrow points to the Meter Setup selection. Press [↓] once to scroll the
text down to the Exit this Menu selection (which is not visible on the display).
MAIN MENU
>Meter Setup
Measurements
MORE:
↑,↓ ENTER:>
Press [↓]
MAIN MENU
>Exit this Menu
Meter Setup
MORE:
↑,↓ ENTER:>
Figure 29: Go to previous step
Example 2: For procedures that require you to enter a numeric value, use the [–] button to decrement the selected numeral.
Figure 30 shows the Low Flow Cutoff parameter display. Notice the cursor under the 3. In this case, press the [–] once to
decrement the numeral to the value of 2.00 %.
LOW FLOW CUTOFF
% of 300.000 GPM
3.00%
CHG: +,- NEXT:E
Press [–]
LOW FLOW CUTOFF
% of 300.000 GPM
2.00%
CHG: +,- NEXT:E
Figure 30: Decrease a value
The [E] button functions as an “Enter” button or “cursor right” button.
Example 1: Figure 31 shows the Main Menu. The selection arrow points to the Meter Setup selection. Press [E] to select Meter
Setup and open the Meter Setup display.
MAIN MENU
>Meter Setup
Measurements
MORE:
↑,↓ ENTER:>
Press [E]
METER SETUP
>Exit this Menu
Scale Factor
MORE:
↑,↓ ENTER:>
Figure 31: Go to meter setup
When you are entering a numeric value, the [E] button does not function as the “Enter” button, but rather, moves the cursor to
the right. When the cursor is at the right-most position, the [E] then serves as the Enter key.
Example 2: The illustration below shows the Low Flow Cutoff display. The cursor is under the 3 in the ones' place. In this case,
press [E] to move the cursor to the right one digit.
LOW FLOW CUTOFF
% of 300.000 GPM
3.00%
CHG: +,- NEXT:E
Press [E]
LOW FLOW CUTOFF
% of 300.000 GPM
3.00%
CHG: +,- NEXT:E
Figure 32: Move the cursor to the right
Programming the M2000 Meter
Page 28 March 2022MAG-UM-01272-EN-21
To Next Page
Loading...
