Badger Meter ModMAG M Series - Page 43

Inputs/Outputs
Digital Output
(continued)
Output Type
[1: Normally Open]
[2: Normally Open]
[3: Normally Open]
[4: Normally Closed]
S
Use Output Type to set the output switch to normally open or normally closed.
If Normally Open is selected, the output switch is open (no current) when the
output is inactive and closed (current flows) when the output is active.
If Normally Closed is selected, the output switch is closed (current flows) when
the output is inactive and open (no current) when the output is active.
To change the Output Type, follow these steps from the Inputs/Outputs
mainmenu:
1. Select Digital Output 1, 2, 3 or 4 and press [E] to open the Digital
Output menu.
2. From the Digital Output menu, select Output Type and press [E] to open
the Output Type display.
3. Select Normally Open or Normally Closed.
4. Press [E] to save the new parameter and return to the Digital
Outputmenu.
Hardware Type
[3: Open Collector]
[4: Solid-state Relay]
S
Use Hardware Type to select the type of hardware used to drive the output
signal: either Open Collector or Solid-state Relay.
To change the Hardware Type, follow these steps from the Inputs/Outputs
mainmenu:
1. Select Digital Output 3 or 4 and press [E] to open the Digital
Output menu.
2. From the Digital Output menu select Hardware Type and press [E] to
open the Hardware Type display.
3. Select Open Collector or Relay.
4. Press [E] to save the new parameter and return to the Digital
Outputmenu.
Using the Main Menu Programming Options
Page 43 March 2022 MAG-UM-01272-EN-21