56 Measurements
BALTECH VP-3470
Operation manual
During the next measurement the previously used channel will be selected
automatically. Make sure that the sensor is connected to the required channel.
To view the measurement results download in to the BALTECH Expert software.
8.4. Time waveform
1. Set up the parameters and press Enter to start the measurement.
There are three ways of starting the measurement:
1) auto- the measurement starts after Enter is pressed/ To stop the measurement
press 0.
2) tacho- the measurement starts only if the tachometer is connected. To perform
a new measurement press 0.
3) manual- after the first measurement is performed the measurement procedure
stops. To perform the next measurement press 0.
To Next Page
Loading...