48 Measurements
BALTECH VP-3470
Operation manual
8. Measurements
The MEASUREMENTS program designed to perform measurement of the vibration
level, vibration phase and rotation frequency. This program has 8 functions (see
Table 4, Figure 30).
Figure 31. Measurements menu
Each function is set up individually (except for the ROUTES). The procedure is as
follows:
1) Parameter setting;
2) Measurement;
3) Saving of the measurement results.
To navigate through the program MEASUREMENTS use the navigation buttons. To
activate the function press Enter. Use Enter to save the parameter settings, to start
the measurement and to save the measurement results. Cancel is used to cancel
all the changes and measurement results.
To Next Page
Loading...