Banner AG4 Series User Manual

Banner AG4 Series Safety Laser Scanner
 The safe design and construction of the machine.
 The safe implementation of the Scanner.
 Providing all relevant information to the user (e.g., all documentation provided with the AG4).
 Compliance with all regulations and directives that allow the user to safely put the machine into operation.
At a minimum, the machine user is responsible for:
 Instructing and supervising the Qualified Person, the Designated Person, and the operator.
 Maintaining the safe operation of the machine.
 Compliance with all occupational health and safety at work regulations and directives.
1.7.1 Passwords
Improperly set parameters on the Scanner can cause serious accidents. The configuration of the Scanner is therefore
protected by passwords.
Ensure that the passwords are secured by the Qualified Person. The default password is "bannera"; call the
numbers on the back cover for assistance in the event of a lost password.
The people responsible for the machine's safety must ensure that the appropriately Qualified Person can properly
perform the tests and work on the machine and the Scanner in accordance with their intended use.
1.7.2 Providing Information for Use
WARNING . . . SCANNER OPERATION ON POWER-UP
It is the responsibility of the user of the Scanner to assess what safeguarding devices and methods are appropriate for any given machine or
application. The Qualified Person who configures, installs, and/or maintains it must be aware of the power-up behavior of the Scanner
and instruct the machine operator on the operation of the Scanner.
At a minimum, the machine manufacturer must provide information to the user to inform the operator of the requirements
for the safe operation of the machine and the Scanner. This also includes providing the necessary instructions needed
by the Designated Person or operator to ensure the safe use of the Scanner (e.g., checkout procedures). The machine
operational instruction materials may never describe a situation that could expose an operator to a hazard.
1.8 Laser
The Scanner has a Class 1 laser. Under
normal conditions, no special precautions are
necessary when working with or handling a
Class 1 laser. Observe the applicable legal
and local regulations for operating laser
equipment.
Figure 1-6. Laser Safety label and its location
1.9 High Voltage
WARNING . . . HIGH VOLTAGE EXISTS INSIDE THE AG4.
Do not open the AG4 with power applied. In connection with fault diagnosis or repair,
such as screen replacement, the unit should only be opened by a Qualified Person.
Otherwise return the Scanner to the factory for repair or replacement. Failure to observe
this warning could result in serious injury or death.
Figure 1-7. High Voltage Safety label and its location
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com

Banner AG4 Series Specifications

General

Brand	Banner
Model	AG4 Series
Category	Scanner
Language	English