Banner AG4 Series Safety Laser Scanner
when the PC transfers the operational parameters to the Scanner. When the original Scanner is replaced and a new
Scanner is connected to power with the ConfigPlug, the plug automatically transfers the configuration into the new
Scanner.
1.4 Product Labels
1.4.1 Product Identification Plate
The product identification plate is located on the side of the Scanner and details information as shown below.
Figure 1-4. Product identification plate
1.4.2 Safety Notice
A Safety notice is located next to the interface connectors, on the Scanner as shown.
Figure 1-5. Safety notice location
1.5 Proper Use and Intended Purpose
Carefully read, understand and follow the Instruction Manuals before using or installing this Scanner. The
literature is contained within the software Help menu or can be downloaded at Banner website.
The Scanner is intended for safeguarding machine hazards and collision avoidance on mobile vehicles.
The user is responsible for satisfying all local, state, and national laws, rules, codes, or regulations relating to
the installation and use of this control system in any particular application. Take extreme care to meet all legal
requirements and follow all installation and maintenance instructions contained in this manual.
The user has the sole responsibility to ensure that the Scanner is appropriate for the application, and is
installed and interfaced by Qualified Persons in accordance with this manual and applicable safety regulations.
The Scanner must be integrated into the machine's control system in such a way that an activation of the safety
function safely stops or interrupts the dangerous process before a person can be endangered.
The Scanner may NOT be used with any machine that cannot be stopped immediately after a stop signal is
issued, such as single-stroke (or "full-revolution") clutched machinery, or any machine with inadequate or
inconsistent machine response time and stopping performance.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com