Banner AG4 Series Safety Laser Scanner
3. Installation
Before installing the Scanner, read Sections 1 and 3 of this manual in their entirety. The System’s ability to
perform its safety guarding function depends upon the appropriateness of the application and upon its proper
mechanical and electrical installation and interfacing to the guarded machine. A risk assessment must determine if the
application of the Scanner is appropriate, which includes the AG4 software configuration and the Protective and
Warning Field coverage.
If all mounting, installation, interfacing, and checkout procedures are not followed properly, the System cannot provide
the protection for which it was designed. Installation must be performed by a Qualified Person, as defined in Section 4.1.
See Warning below.
WARNING . . . READ THIS SECTION CAREFULLY BEFORE INSTALLING THE SYSTEM
The user is responsible for satisfying all local, state, and national codes and regulations relating to the installation and use of this
control system in any particular application. Take extreme care to meet all legal requirements and follow all technical installation
and maintenance instructions contained in this manual.
The user has the sole responsibility to ensure that the Scanner is installed and interfaced to the guarded machine by Qualified
Persons in accordance with this manual and with applicable safety regulations.
Read Section 1 and all of Section 3 of this manual carefully before installing the System. Failure to follow these instructions could
result in serious bodily injury or death.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
Need help?
General
