Table 27: BCR Control and Status Module (Ident 0x00000011)
Number of Physical Subslots Subslot Label Subslot Number
1 1.1 BCR Inspection Result Submodule 1 (0x1)
1 1.2 BCR Device Control Submodule 2 (0x2)
Table 28: BCR Sensor Output Module (Ident 0x00000041)
Number of Physical Subslots Subslot Label Subslot Number
1 2.1 sensor output submodules 1 (0x1)
Table 29: BCR Control Module (Ident 0x00000020)
Number of Physical Subslots Subslot Label Subslot Number
1 Compare String submodules 1 (0x1)
Table 30: Command Channel Module (Ident 0x00000030)
Number of Physical Subslots Subslot Label Subslot Number
1 4.1 Command Channel Command submodules 1 (0x1)
1 4.2 Command Channel Response submodules 2 (0x2)
Description of Submodules
Table 31: Supported Submodules and Locations
Submodules Location Notes
BCR Inspection Result Submodule Slot 1,Subslot 1 Always present.
BCR Device Control Submodule Slot 1, Subslot 2 Present by default, but can be removed.
Sensor Output – First Barcode Submodule Slot 2, Subslot 1 There are six versions of this submodule supporting
command strings of 16, 32, 64, 128, 256, and 512 bytes.
Sensor Output – Multiple Barcodes Submodule Slot 2, Subslot 1 Predefined with space for 10 barcodes.
Compare String Submodule Slot 3, Subslot 1 There are six versions of this submodule supporting
command strings of 16, 32, 64, 128, 256, and 512 bytes.
Command Channel Command Submodule Slot 4, subslot 1 There are four versions of this submodule supporting
command strings of 0, 32, 64, and 128 bytes.
Command Channel Response Submodule Slot 4, subslot 2 There are four versions of this submodule supporting
command strings of 0, 32, 64, and 128 bytes.
Inspection Result Submodule
The Inspection Result Submodule contains inspection results and sends input data to the controller (PLC). This submodule
is plugged into Slot 1 Subslot 2 and cannot be removed.
iVu Plus BCR Gen2 Series Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 133
To Next Page
Loading...
