9. Add modules and submodules.
Changing the Device IP Address
Use these instructions for the Siemens SIMATIC STEP 7 (v5.5) software.
1. Start Siemens SIMATIC Manager.
2. Select an existing project and open it.
3. Select the Station (PLC) from the Object Hierarchy list.
Figure 158. Object Hierarchy List
4. Double-click the Hardware icon in the Station level window to open the Hardware configuration window.
Figure 159. Double-click the Hardware Icon
5. Select PLC > Ethernet > Edit Ethernet Node.
Figure 160. Select Edit Ethernet Note
6. Click Browse... under Nodes accessible online in the Edit Ethernet Node window.
iVu Plus BCR Gen2 Series Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 159
To Next Page
Loading...
