Error Code Description Recommended Solution
10111 The connection to the sensor was
aborted by this application due to
an internal processing error.
• Install an newer version of this application
• Verify the device at the specified IP address is a Banner Vision
sensor
• Verify the sensor's firmware version is compatible with this
application
• Check the
firewall setup on computer
• Go to Sensor Neighborhood and reconnect to the sensor
10120 The connection to the sensor was
aborted by this application due to
an internal processing error.
• Install an newer version of this application
• Verify the device at the specified IP address is a Banner Vision
sensor
• Verify the sensor's firmware version is compatible with this
application
• Check the
firewall setup on computer
• Go to Sensor Neighborhood and reconnect to the sensor
10125 The connection to the sensor was
aborted by this application due to
an internal processing error.
• Install an newer version of this application
• Verify the device at the specified IP address is a Banner Vision
sensor
• Verify the sensor's firmware version is compatible with this
application
• Check the
firewall setup on computer
• Go to Sensor Neighborhood and reconnect to the sensor
10126 The connection to the sensor was
aborted by this application due to
an internal processing error.
• Install an newer version of this application
• Verify the device at the specified IP address is a Banner Vision
sensor
• Verify the sensor's firmware version is compatible with this
application
• Check the
firewall setup on computer
• Go to Sensor Neighborhood and reconnect to the sensor
10140 The Connection to the sensor was
lost due to network keep alive
expiration.
• Install an newer version of this application
• Verify the device at the specified IP address is a Banner Vision
sensor
• Verify the sensor's firmware version is compatible with this
application
• Check the
firewall setup on computer
• Go to Sensor Neighborhood and reconnect to the sensor
10150 The connection to the sensor was
aborted by this application due to
an internal processing error.
• Install an newer version of this application
• Verify the device at the specified IP address is a Banner Vision
sensor
• Verify the sensor's firmware version is compatible with this
application
• Check the
firewall setup on computer
• Go to Sensor Neighborhood and reconnect to the sensor
10190 The connection to the sensor was
aborted by this application due to
an internal threading error.
• Install an newer version of this application
• Verify the device at the specified IP address is a Banner Vision
sensor
• Verify the sensor's firmware version is compatible with this
application
• Check the
firewall setup on computer
• Go to Sensor Neighborhood and reconnect to the sensor
20000 An application error occurred while
refreshing the display. An
unhandled exception was detected.
• Go to Sensor Neighborhood and reconnect to the sensor
20001 An application error occurred while
refreshing the display. There was a
problem parsing data from the
sensor.
• Go to Sensor Neighborhood and reconnect to the sensor
iVu Plus BCR Gen2 Series Sensor
190 www.bannerengineering.com - Tel: + 1 888 373 6767
To Next Page
Loading...
