Error Code Description Recommended Solution
20010 An application error occurred while
refreshing the display. There was a
problem creating screen elements.
• Go to Sensor Neighborhood and reconnect to the sensor
20011 An application error occurred while
refreshing the display. There was a
problem releasing screen elements.
• Go to Sensor Neighborhood and reconnect to the sensor
20020 An application error occurred while
refreshing the display. There was a
problem synchronizing data.
• Go to Sensor Neighborhood and reconnect to the sensor
20021 An application error occurred while
refreshing the display. There was a
problem releasing data resources.
• Go to Sensor Neighborhood and reconnect to the sensor
20030 An application error occurred while
refreshing the display. There was a
problem synchronizing with the
inspection.
• Go to Sensor Neighborhood and reconnect to the sensor
20040 An application error occurred while
refreshing the display. There was a
problem updating input data.
• Go to Sensor Neighborhood and reconnect to the sensor
20041 An application error occurred while
refreshing the display. There was a
problem updating result data.
• Go to Sensor Neighborhood and reconnect to the sensor
20050 This application detected an error
while refreshing the display. There
was a problem rendering the
image.
• Go to Sensor Neighborhood and reconnect to the sensor
20060 An application error occurred while
refreshing the display. There was a
problem updating pixel
annotations.
• Go to Sensor Neighborhood and reconnect to the sensor
20061 An application error occurred while
refreshing the display. There was a
problem updating pixel
annotations.
• Go to Sensor Neighborhood and reconnect to the sensor
20070 An application error occurred while
refreshing the display. There was a
problem updating vector
annotations.
• Go to Sensor Neighborhood and reconnect to the sensor
20071 An application error occurred while
refreshing the display. There was a
problem updating vector
annotations.
• Go to Sensor Neighborhood and reconnect to the sensor
20072 An application error occurred while
refreshing the display. There was a
problem releasing vector
annotations.
• Go to Sensor Neighborhood and reconnect to the sensor
20150 Connection to the emulator failed. • Call Banner Customer Support
20151 There was an error starting the
emulator.
• Reinstall this application
• Check the firewall setup on computer
20152 The selected emulator could not be
found.
• Reinstall this application
• Check the firewall setup on computer
20153 There was a problem closing the
previous emulator session.
• Reboot the computer to end any processes which did not shut
down properly
iVu Plus BCR Gen2 Series Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 191
To Next Page
Loading...
