Figure 65. Local Area Connection Properties Screen
5. In Internet Protocol (TCP/IPv4) Properties, select Use the following IP address.
6. Make sure that the IP address is 192.168.0.2, and the subnet mask is 255.255.255.0.
Figure 66. Internet Protocol (TCP/IPv4) Properties Screen
iVu BCR Setup for Ethernet Communications
1. Go to Main Menu > System > Communications > Ethernet I/O and make sure that the iVu BCR is configured as
shown.
Figure 67. Ethernet I/O Screen
2. Enable the command channel over Ethernet.
a. Go to Main Menu > System > Communications > Command Channel > Connection, and select Ethernet [IP
Port # 32000].
iVu Plus BCR Gen2 Series Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 75
To Next Page
Loading...
