Figure 68. Connection Screen
b. Configure the field and end-of-frame delimiters. Go to Main Menu > System > Communications > Command
Channel > Delimiters.
Figure 69. Delimiters Screen
Valid end-of-frame delimiters are: <comma>, <colon>, <semicolon>, <CR>, <CR><LF>, <LF><CR>, or
<ETX>.
c. Verify that the iVu BCR receives and transmits data correctly.
3. Enable Data Export over Ethernet.
a. Go to Main Menu > System > Communications > Data Export > Connection and select Serial I/O from the
drop-down.
Figure 70. Connection Screen
b. Go to Main Menu > System > Communications > Data Export > Data To Export and select the inspection
data to export.
Figure 71. Data to Export Screen
iVu Plus BCR Gen2 Series Sensor
76 www.bannerengineering.com - Tel: + 1 888 373 6767
To Next Page
Loading...
