Banner iVu Plus BCR Gen2 Series - Page 87

Command Group Item Description
Set Ethernet SubnetMask Set a new subnet mask. A Reboot command is required to be sent from
the command channel to make the new mask effective.
Set Ethernet Gateway Set a new Gateway IP address. A Reboot command is required to be
sent from the command channel to make the new address effective.
Examples
>> Do System Reboot\x0D\x0A
<< (No response received)
>> Get Ethernet IP Address\x0D\x0A
<< OK\x0D\x0A
<< "192.168.0.115"\x0D\x0A
>> Set Ethernet IPAddress 192.168.0.114\x0D\x0A
<< OK\x0D\x0A
Status Command Group
Command
Group Item Description
Get Status Ready Flag indicating whether the system is ready to trigger (true) or busy
(false).
Get Status SystemError Flag indicating whether a system error is active (true) or cleared (false).
Do Status ClearSystemError Clears the system error LED and sets the internal flag to false.
Examples
>> get status ready\x0D\x0A
<< OK\x0D\x0A
<< True\x0D\x0A
>> get status systemerror\x0D\x0A
<< OK\x0D\x0A
<< False\x0D\x0A
>> do status clearsystemerror\x0D\x0A
<< OK\x0D\x0A
Trigger Command Group
Command
Group Item Description
Get Trigger Mode Get the trigger mode.
Set Trigger Mode Sets the trigger mode to one of the valid trigger modes for the device.
This remotely modified value is not persisted to the device's permanent
memory. The Save command is required to persist this value.
Do Trigger Immediate Initiates a single trigger and inspection. The device does not transmit a
response until the device has completed the action and returned to the
READY state. This command requires the Command trigger mode. The
device must be in the ready state to perform the desired operation.
Do Trigger Gated Initiates the gated triggering mode. Images are repeatedly acquired until
a valid object is detected or this mode is aborted. The device does not
transmit a response until the device has completed the action and
returned to the READY state. This command requires the Command
trigger mode. The device must be in the ready state to perform the
desired operation.
iVu Plus BCR Gen2 Series Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 87