Command Group Item Description
Do Trigger AbortGated Aborts the gated triggering mode. The device does not transmit a
response until the gated triggering option has been aborted and the
device has returned to the READY state. This command requires the
Command trigger mode.
Examples
>> get trigger mode\x0D\x0A
<< OK\x0D\x0A
<< Command\x0D\x0A
>> set trigger mode command\x0D\x0A
<< OK\x0D\x0A
Imager Command Group
Command
Group Item Description
Get Imager Gain Get the device's value used to electronically brighten all image pixels.
This remotely modified value is not persisted to the device's permanent
memory. The Save command is required to persist this value.
Set Imager Gain The device's value used to electronically brighten all image pixels. This
remotely modified value is not persisted to the device's permanent
memory. The Save command is required to persist this value.
Get Imager Exposure Get the device's value used to control the amount of time the imager
gathers light for the image. This remotely modified value is not persisted
to the device's permanent memory. The Save command is required to
persist this value.
Set Imager Exposure The device's value used to control the amount of time the imager
gathers light for the image.This remotely modified value is not persisted
to the device's permanent memory. The Save command is required to
persist this value.
Examples
>> get imager exposure\x0D\x0A
<< OK\x0D\x0A
<< Command\x0D\x0A
>> set imager exposure"11900"\x0D\x0A
<< OK\x0D\x0A
Teach Command Group
Command
Group Item Description
Do Teach NextTrigger Forces the device to perform the Remote Teach operation on the next
trigger. This command can be performed using the device's display.
Examples
>> do teach\x0D\x0A
<< OK\x0D\x0A
iVu Plus BCR Gen2 Series Sensor
88 www.bannerengineering.com - Tel: + 1 888 373 6767
To Next Page
Loading...
