Examples
>> get history passed\x0D\x0A
<< OK\x0D\x0A
<< 13\x0D\x0A
>> get history startframenumber\x0D\x0A
<< OK\x0D\x0A
<< 3\x0D\x0A
>> do history clear\x0D\x0A
<< OK\x0D\x0A
Inspection Command Group
Command Group Item Description
Get Inspection Status The status of the most recent inspection either Pass, Fail, or Idle (no
triggers).
Get Inspection Name The name of the active inspection.
Get Inspection FrameNumber The most recent inspection frame number.
Get Inspection ExecutionTime The most recent inspection execution time in milliseconds.
Examples
>> get inspection status\x0D\x0A
<< OK\x0D\x0A
<< Fail\x0D\x0A
>> get inspection executiontime\x0D\x0A
<< OK\x0D\x0A
<< 37.739\x0D\x0A
BCR_INPUT Command Group
Command
Group Item Description
Get BCR_INPUT CompareData Get the Barcode inspection compare data string. This string must start
and end with the double quote character.
Set BCR_INPUT CompareData The Barcode inspection compare data string. This string must start and
end with the double quote character. This value can be modified using
the sensor's touchscreen. The Save command is required to persist this
value.
Get BCR_INPUT CompareMask Get the Barcode inspection compare string mask in binary format.
Set BCR_INPUT CompareMask The Barcode inspection compare string mask in binary format; that is,
masked characters are indicated by a "1" and unmasked characters are
"0." Note that the mask character string must match the length of the
compare string. This remotely
modified value is not persisted to the
sensors permanent memory. The Save command is required to persist
this value.
Example
>> set BCR_Input CompareData "mydata"
<< OK\x0D\x0A
iVu Plus BCR Gen2 Series Sensor
90 www.bannerengineering.com - Tel: + 1 888 373 6767
To Next Page
Loading...
