System manual Coronis 5MP 50
Wizard. The wizard will then begin to install the next piece of software
that was selected when you initially launched the Barco Software
Install Wizard. If no additional pieces of software were selected,
you may either click
“Finish”“Finish”
“Finish”“Finish”
“Finish” to exit the Barco Software Install
Wizard or
“Back”“Back”
“Back”“Back”
“Back” to return to the Welcome Screen and select
additional software to be installed and then click
“Inst“Inst
“Inst“Inst
“Inst
all”all”
all”all”
all”.
Figure 9
6. The Device Selection Screen (figure 10) shows the devices
supported by the driver on the CD. Under Windows NT the wizard
does not detect the physical hardware installed in the computer.
Since Windows NT supports only one type of video device at a
time, you may choose only one type of device to install. After you
have selected the device you want to install, click
“Next”“Next”
“Next”“Next”
“Next”.
Figure 10
If you selected a device with an existing driver, the existing driver’s
version will be compared against the version of the driver you are
installing. If the existing driver’s version is newer than the one you
are installing, the Wizard will warn you that the current driver is
newer than the one you installing (see figure 11 on the next page).
BarcoMed software driver installation
To Next Page
Loading...
