System manual Coronis 5MP 51
If you choose to continue, your existing driver will be replaced. Click
“OK” “OK”
“OK” “OK”
“OK” to continue. If you want to change your selection, click
“OK”“OK”
“OK”“OK”
“OK” to continue and then click
“Back”“Back”
“Back”“Back”
“Back” on the next screen.
Figure 11
7. The Device Confirmation Screen (figure 12) lists the device that
will be installed. If you want to change your selection, click
“Back”“Back”
“Back”“Back”
“Back”
and you will see the previous screen. To begin installation, click
“Next”“Next”
“Next”“Next”
“Next”. If you want to end the installation without installing the
driver, click
“Cancel” “Cancel”
“Cancel” “Cancel”
“Cancel” and the Wizard will exit.
SS
SS
S
pecial Note: pecial Note:
pecial Note: pecial Note:
pecial Note: Once you click
“Next”, “Next”,
“Next”, “Next”,
“Next”, you cannot cancel the driver
installation.
Figure 12
During the BarcoMed driver installation, the install progress
window is displayed (figure 13 on the next page).
BarcoMed software driver installation
To Next Page
Loading...
