System manual Coronis 5MP 52
Figure 13
8. If the Wizard has successfully installed the drivers for all of the
displays supported by your BarcoMed Display Controller(s), the
Wizard will advise you that the installation is complete and prompt
you to click
“Finish”“Finish”
“Finish”“Finish”
“Finish” (see figure 14). Click
“Finish”“Finish”
“Finish”“Finish”
“Finish” to finish
installing the display drivers and return to the BarcoMed Product
Install Wizard. Clicking
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel” will also return you to the
BarcoMed Product Install Wizard, but will not delete the Barco
Display Drivers.
Figure 14
If the Wizard failed to successfully install the drivers for all of the
displays supported by your BarcoMed Display Controller(s), the
Wizard will advise you that the installation failed (see figure 15 on
the next page). Click
“Finish”“Finish”
“Finish”“Finish”
“Finish” to exit the Driver Install Wizard and
to return to the BarcoMed Product Install Wizard.
After returning to the BarcoMed Product Install Wizard Welcome
Screen, the wizard will automatically begin installing the next
selected piece of BarcoMed Software. If you are working with the
default selections, this will be the BARCO DPMS InstallShield
BarcoMed software driver installation
To Next Page
Loading...
