System manual Coronis 5MP 65
Figure 30
The BarcoMed Product Installation Wizard may prompt you to
restart your system. If it does, you must restart your system in
order for the updated version of the Microsoft Installer to be
effective and to be able to install the software on your BarcoMed
Software CD (figure 31). Click
“Y“Y
“Y“Y
“Y
es”es”
es”es”
es” to restart your system.
Figure 31
When your system restarts log in using an account with
administrator privileges. When your system restarts Windows
2000 will again automatically launch the “Found New Hardware
Wizard”. Click
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel” to exit the “Found New Hardware
Wizard”. Continue to click
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel” until Windows 2000 stops
launching the “Found New Hardware Wizard - Video Controller”.
6. The BarcoMed Product Installation Wizard’s welcome screen will
now be displayed. By default all the software on the BarcoMed
Software CD will be selected (figure 32). For the initial installation
we recommend that you install all of the software. If you do not
want to install a particular BarcoMed Software product, deselect it
by clearing the checkbox next to it.
When you have selected the BarcoMed Software you wish to
install click
“Inst“Inst
“Inst“Inst
“Inst
all”all”
all”all”
all” on the Wizard’s Welcome Screen to continue
or
“Cancel” “Cancel”
“Cancel” “Cancel”
“Cancel” to exit the wizard.
If you click
“Cancel” “Cancel”
“Cancel” “Cancel”
“Cancel” the wizard will exit.
BarcoMed software driver installation
To Next Page
Loading...
