System manual Coronis 5MP 67
Figure 33
If you select
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel”, a dialog box (figure 34) will open asking
you to confirm cancellation of the install process. If you choose
“No”“No”
“No”“No”
“No”, the Wizard will continue normally. If you choose
“Y“Y
“Y“Y
“Y
es”es”
es”es”
es”, the
Wizard will exit and return you to the Barco Software Install
Wizard. The wizard will then begin to install the next piece of
software that was selected when you initially launched the Barco
Software Install Wizard. If no additional pieces of software were
selected, you may either click
“Finish”“Finish”
“Finish”“Finish”
“Finish” to exit the Barco Software
Install Wizard or
“Back”“Back”
“Back”“Back”
“Back” to return to the Welcome Screen and
select additional software to be installed and then click
“Inst“Inst
“Inst“Inst
“Inst
all”all”
all”all”
all”.
Figure 34
8. The Device Selection Screen’s dialog box should show only those
devices physically installed and supported by the Barco graphics
device driver on your CORONIS Software CD (see figure 35 onthe
next page). If there are no Barco devices installed or if the driver
on your CORONIS Software CD does not support the installed
devices, the dialog box will be empty, and program will exit when
the user clicks
“Finish”“Finish”
“Finish”“Finish”
“Finish” or
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel”. Select the device you want
to install and then click
“Next”“Next”
“Next”“Next”
“Next”. If you have multiple types of
BarcoMed software driver installation
To Next Page
Loading...
