System manual Coronis 5MP 68
BarcoMed devices installed in your computer that are supported by
the driver on your CORONIS Software CD, you will need to rerun
the installer to install the other devices.
Figure 35
If you selected a device with an existing driver, the existing driver’s
version will be compared against the version of the driver you are
installing. If the existing driver’s version is newer than the one you
are installing, the Wizard will warn you that the current driver is
newer than the one you installing (see figure 36). If you choose to
continue, your existing driver will be replaced. Click
“OK” “OK”
“OK” “OK”
“OK” to
continue.
Figure 36
If you want to change your selection, click
“OK”“OK”
“OK”“OK”
“OK” to continue and
then click
“Back”“Back”
“Back”“Back”
“Back” on the next screen.
9. Your selection on the screen shown in figure 38 will determine if
DualView is enabled or not. DualView allows a dual head display
controller to display two separate desktops, one for each display
instead of a single virtual desktop that spans across both displays.
DualView is a feature that is automatically supported by Windows
XP. However, BARCO has provided a means for you to enable this
functionality while running Windows 2000. Figures 37 and 38
BarcoMed software driver installation
To Next Page
Loading...
