System manual Coronis 5MP 70
If DualView is not enabled, you will see a single virtual screen in
the display properties dialog for both heads of a BarcoMed Display
Controller. If DualView is enabled, you will see two virtual screens
in the dialog box on the Settings Tab of the Display Properties
Control Panel, one for each head of the BarcoMed Display
Controller. If you wish to enable DualView
“check”“check”
“check”“check”
“check” the checkbox
next to “Enable the DualView device.”, and click
“Next”“Next”
“Next”“Next”
“Next”. If you do
not wish to enable DualView simply click
“Next” “Next”
“Next” “Next”
“Next” to continue.
Figure 39
10. The screen shown in figure 40 on the next page displays the
device(s) that will be installed. If you want to change your
selection, click BACK and you will see the previous screen. To
begin installation, click
“Next” “Next”
“Next” “Next”
“Next” to continue. If you want to end the
installation without installing the driver, click
“Cancel” “Cancel”
“Cancel” “Cancel”
“Cancel” and the
wizard will exit.
SS
SS
S
pecial Note:pecial Note:
pecial Note:pecial Note:
pecial Note: Once you click
“Next”, “Next”,
“Next”, “Next”,
“Next”, you cannot cancel the driver
installation
BarcoMed software driver installation
To Next Page
Loading...
