System manual Coronis 5MP 73
Figure 44
If the Wizard failed to successfully install the drivers for all of the
displays supported by your BarcoMed Display Controller(s), the
Wizard will advise you that the installation failed (see figure 45 on
the next page). Click
“Finish”“Finish”
“Finish”“Finish”
“Finish” to exit the Driver Install Wizard and
to return to the BarcoMed Product Install Wizard.
After returning to the BarcoMed Product Install Wizard Welcome
Screen, the wizard will automatically begin installing the next
selected piece of BarcoMed Software. If you are working with the
default selections, this will be the BARCO DPMS InstallShield
Wizard, click
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel”. The wizard will ask you to confirm that
you want to cancel the DPMS installation, click
“Y“Y
“Y“Y
“Y
es”es”
es”es”
es” and then
click
“Finish”“Finish”
“Finish”“Finish”
“Finish”. The BARCO DPMS InstallShield Wizard will exit
and return to the BarcoMed Product Install Wizard Welcome
Screen, the wizard will automatically launch the CORONIS
Rotation Service Install Wizard, click
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel”. The wizard will
ask you to confirm that you want to exit the CORONIS Rotation
Service setup, click
“Exit Setup”. “Exit Setup”.
“Exit Setup”. “Exit Setup”.
“Exit Setup”. The wizard will exit and return
you to the BarcoMed Product Installation Wizard. Then click
“Back”“Back”
“Back”“Back”
“Back” and try reinstalling the drivers following the steps above or
using the steps outlined in “Reinstalling or Updating your
BarcoMed Drivers” section found later in this chapter.
SS
SS
S
pecial Note:pecial Note:
pecial Note:pecial Note:
pecial Note: If you installed the drivers with DualView disabled,
Windows 2000 will still show two devices installed for each BarcoMed
Display Controller installed under “Display Adapters” in the “Device
Manager Control Panel”. The second device will be disabled. This is
normal. Do
NOTNOT
NOTNOT
NOT try to enable any of the disabled display adapters. If
you wish to enable DualView, you will need to reinstall the drivers with
the “Enable the DualView device?” checked.
BarcoMed software driver installation
To Next Page
Loading...
