System manual Coronis 5MP 72
Figure 42
13. For each display supported by your BarcoMed Display
Controller(s) the Wizard will display the screen shown in figure 43.
Click
“Y“Y
“Y“Y
“Y
es”es”
es”es”
es” to continue.
Figure 43
14. If the Wizard has successfully installed the drivers for all of the
displays supported by your BarcoMed Display Controllers Display
Controller(s), the Wizard will advise you that the installation is
complete and prompt you to click
“Finish”“Finish”
“Finish”“Finish”
“Finish” (see figure 44 on the
next page). Click
“Finish”“Finish”
“Finish”“Finish”
“Finish” to finish installing the display drivers
and return to the BarcoMed Product Install Wizard. Clicking
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel” will also return you to the BarcoMed Product Install
Wizard, but will not delete the Barco Display Drivers.
BarcoMed software driver installation
To Next Page
Loading...
