System manual Coronis 5MP 89
Figure 62
9. Click
“Next”“Next”
“Next”“Next”
“Next” on the Barco Device Driver Setup Wizard’s Welcome
Screen to continue or
“Cancel” “Cancel”
“Cancel” “Cancel”
“Cancel” to exit the Barco Device Driver
Setup Wizard (see figure 63).
Figure 63
If you select
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel”, a dialog box (figure 64) will open asking
you to confirm cancellation of the install process. If you choose
“No”“No”
“No”“No”
“No”, the Wizard will continue normally. If you choose
“Y“Y
“Y“Y
“Y
es”es”
es”es”
es”, the
Wizard will exit and return you to the Barco Software Install
Wizard. The wizard will then begin to install the next piece of
software that was selected when you initially launched the Barco
Software Install Wizard. If no additional pieces of software were
selected, you may either click
“Finish”“Finish”
“Finish”“Finish”
“Finish” to exit the Barco Software
BarcoMed software driver installation
To Next Page
Loading...
