System manual Coronis 5MP 90
Install Wizard or
“Back”“Back”
“Back”“Back”
“Back” to return to the Welcome Screen and select
additional software to be installed and then click
“Inst“Inst
“Inst“Inst
“Inst
all”all”
all”all”
all”.
Figure 64
10. The Device Selection Screen’s dialog box should show only those
devices physically installed and supported by the Barco device
driver on your BarcoMed Software CD (figure 65). If there are no
Barco devices installed or if the driver on your BarcoMed Software
CD does not support the installed devices, the dialog box will be
empty, and program will exit and return to the BarcoMed Product
Install Wizard when the user clicks
“Finish”“Finish”
“Finish”“Finish”
“Finish” or
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel”. Select
the device you want to install, and then click
“Next”“Next”
“Next”“Next”
“Next”. If you have
multiple types of BarcoMed devices installed in your computer that
are supported by the driver on your CORONIS Software CD, you
will need to rerun the installer to install the other devices.
Figure 65: Supported Devices Screen
11. If you selected a device with an existing driver, the existing driver’s
version will be compared against the version of the driver you are
installing. If the existing driver’s version is newer than the one you
BarcoMed software driver installation
To Next Page
Loading...
