6. Lamp & lamp house
Image 6-10
3. Install the lam p cathode adaptor (A) up o n the xenon bulb lamp (L) as illustrated. Use
torque 2,5 Nm to fasten the fix ation screw
(S)oftheadapter. Useforthatatorquewrenchwitha5mmAllensocket. Makesurethatthereisfullcontactbetweenthe
cathode adapter an d the lamp base.
Note: The cathode lamp adaptor is delivered in a separate bag with t
he projector. In case of a lamp replacement you have to
reuse the adaptor from the xenon bulb lamp which you want to replace.
S
L
A
2,5 Nm
Image 6-11
4. Install the anode wire lug (L) upon the anode s ocket (S). Hold fast the nut N1 with an open-end wrench while fastening the nut N2
with a torque of 9Nmusing a torque wrench. Ens ure that at both sides of the wire lug L a plane w asher (W1 & W2) is present.
Note: The anode socket is located just below the UV blocker and can easily be removed from the lamp house. In case of a lamp
replacement you have to reuse the anode socket which is connected to the xenon bulb lamp which you want to replace.
R59770091 DP-1500 06/01/2009
53
To Next Page
Loading...
