6. Lamp & lamp house
L
N2
S
W1
W2
N1
N1
N2
9 Nm
Image 6-12
5. Remov e the protective container or unwrap the protective cloth from the xenon bulb lamp.
Warning: Ensure that you wear protective clothing, a full face shield and protective gloves.
Tip: Write down the serial number of the lamp. You will need this while updating the lamp parameters after installation of the
lamp. The serial number of the lamp is engraved in the neck of the xenon bulb lamp.
6. Gently guide the xenon bulb lamp into position inside the lamp house as illustrated. An ode socket han ging vertical down. W hile
inserting the lamp, rotate it slightly, engaging the pins of the cathode adapter in the foreseen s lots. This is to ensure the lamp
cathode is completely ins erted.
Warning: Make sure that the both pins of the cathode adapter are engaged in the foreseen slots.
Image 6-13
7. Insert the anode socket into position as illustrated.
Caution: Avoid any tension on the anode wire, so there is no mechanical stress on the bulb of the lamp.
54
R59770091 DP-1500 06/01/2009
To Next Page
Loading...
