12. Lamp House & Lamp replacement
12.3 Lamp replacement process
About this process
This process enumerates all procedures in a c hronological order for replacem ent of the xenon lamp of the projector. The stages in
this process refer to the detailed step by s tep procedures included in this d ocum ent.
Lamp replacement process from A to Z
1. Put the projector in standby mode, wait 15 minutes to let the projector cool dow n (after cooling), and then sw itch off the projector.
15min
Image 12-5
2. R emove the cover of the Lamp Ho use compartment. See page 118.
Image 12-6
3. R emov e the Lam p House from the projector. See page 83.
Image 12-7
4. R emov e the exhausted xenon lam p from the La mp H ouse. See page 89.
Image 12-8
5. Perform m aintenance actions for lamp replacement. See page 104.
6. Install a new xenon lam p in the Lam p House. S ee page 89.
R5977692 DP2K-S SERIES 10/12/2012
81
To Next Page
Loading...
