5. Advanced operation
5.4.2 Language
About languages
The available languages for your display are:
•English
• Français
•Deutsch
• Español
• Italiano
To select the language
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the Language submenu.
4. Select one of the available languages and confirm.
5.4.3 Failover m ode
About failover mode
This function allows the automatic switch to a defined Backup source when the Main input signal is miss-
ing.
The display will automatically restore the Main input as soon as the signal is back.
The Backup source is the input selected as “2nd Picture Source” with “2nd Picture Mode” = “Off”.
This Main & Backup combination is stored at the moment the function “Failover mode” is set to “Enabled”.
Failover Mode is not selectable when either the Main Source or the 2nd Picture Source is set to “Au-
tosearch”.
Failover mode is automatically disabled when either the Main Source or the 2nd Picture
Source is changed. A warning message “Failover off” appears on the screen for a few
seconds.
Returning to the original Main & B ackup comb ination will automatically re-enable the
Failover feature.
For the M NA version only, Failover mode will be activated 7 seconds after the Nexxis
signal becomes una vailable (delay required t o allow a Nexxis layout change)..
To enable/disable failover mode
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the Failover mode submenu.
4. Enable/Disable failover mode as desired and confirm.
(451920611391)K5903031 MDSC-2224 21/01/2014
41
To Next Page
Loading...
Need help?
General
