6. Important information
6.5 Clean ing a n d disinfection
Instructions
• Be sure to unplug the power cord from the mains when cleaning your LCD monitor.
• Take care not to scratch the front surface with any hard or abrasive material.
•Dust,finger marks, grease etc. can be removed with a soft damp cloth (a small amount of mild deter-
gentcanbeusedonthedampcloth).
• Wipeoffwaterdropimmediately.
Possible cleaning s olutions
• 70 percent isopropyl alcohol
• 1.6 percent aqueous ammonia
• Cidex® (2.4 percent glutaraldehyde solution)
• Sodium hypochlorite (bleach) 1 0 percent
• “Green soap” (USP)
• 0.5 percent Chiorhexidine in 70 percent isopropyl alcohol.
• Like Cleansafe® optical cleaning liquid
6.6 Exp lanation of symbols
Symbols on the device
On the device or power supply, you may find the following symbols (nonrestrictive list):
Indicates the device meets the requirements of the applicable EC directives.
Indicates compliance with Part 15 of the FCC rules (Class A or Class B)
Indicates the device is approved according to the UL Recognition regulations
Indicates the device is approved according to the UL Demko regulations
Indicates the device is approved according to the CCC regulations
Indicates the device is approved according to the VCCI regulations
Indicates the device is approved according to the KC regulations
Indicates the device is approved according to the BSMI regulations
(451920611391)K5903031 MDSC-2224 21/01/2014 53
To Next Page
Loading...
Need help?
General
