Barco RLM W6 - Pip Position; Pip Select

41
PIP Select
Use this function to select the source for the
sub window.
You can choose from HDMI1, HDMI2,
RGB D-15(RGB-HV/SOG), YUV1,
RGBHV/YUV2, Composite Video(Video),
S-Video, RGB-S and so forth.
PIP Position
You can choose to display the
sub window in five different
location over the main picture
according to your preference.
PIP
If you wish to display PIP image, you can make the configuration here.By choosing "ON", you
will see two windows on the projected image; the larger one is the primary image and the
smaller one is the sub image.By choosing "OFF", the PIP function will be disabled and you
will only see a single image window.
*please refer to the following main and PIP source matrix for a valid main and PIP source selection when PIP is ON.*
HDMI1 HDMI2 RGB YUV1 RGBHV/ Composite S-Video RGB-S
D-15 YUV2 Video
HDMI 1 – O O O O O O
HDMI 2 – O O O O O O
RGB D-15 O O – – O O O
YUV 1 O O – – O O –
RGBHV/ YUV 2 O O – – O O –
Composite Video O O O O O – –
S-Video O O O O O – –
RGB-S O O O – – – –
O mean Source Available ; — mean NA
Main Select
PIP
Select
6
OSD Menu description
Sub picture
Main picture
Split L-R
Bottom RightBottom Left
Top RightTop Left