7
Should you encounter any of the following situation, please unplug your projector from the
wall outlet and contact a qualified service personnel for assistance:
•
Damaged power cord or power plug.
•
If a foreign object has fallen into the projector or if you have spilled water or other liquid
into the projector.
•
If the projector has been dropped accidentally or damaged.
•
If you experience noticeably poor performance or malfunctioning with the projector despite
having followed instructions for normal operation.
Changing parts
Should any part of the projector be damaged, check with your servicing personnel that only
manufacturer certified parts were used for replacement. Used of non-certified parts may
result in damages to the projector or hazards such as fire or electric shock.After changing
parts, be sure to remind the servicing personnel to perform safety inspections to ensure that
the projector operates normally.
Power cord
Don't place the projector where the cord can be walked on. This may result in fraying or
damage to the power cord, especially at the plug and the point of connection between the
power cord and the projector.
Please use the power cord that comes with the projector or the type of power cord specified
for the projector (refer to the descriptions printed on the power cord). If you are not sure of
the power available at the region you are in, consult your local power company to prevent
damages to the projector due to the use of wrong power cord or potential fire hazards due to
current overload.
Depending on the country and region you are in, the voltage and type of socket of the wall
outlet may be different from the projector. If you are unable to fit the power plug into the wall
outlet, contact your local dealer and do not remove the extra pin on the power plug to forcibly
fit it to the socket at the risk of your own safety.
Notices you should read prior to the
installation of the projector
Safety issues related to the lamp
The lamp used in this projector contains mercury. Should the lamp be broken, please be
careful when handling the glass shards and keep the surrounding environment well ventilated.
Be sure to wear a mask that offers adequate protection before cleaning up to prevent inhaling
mercury vapor that could cause bodily harm.For instructions on lamp replacement, refer to
the chapter "Maintenance & Troubleshooting" Replacing the Lamp
Take frequent breaks to let your eyes rest
Prolonged viewing of the projector screen could strain your eyes. Please be sure to rest your
eyes adequately.
Installation environment for the projector
You should avoid installing the projector at place of excessive dampness, dust or smoke.
If installation in such environment is unavoidable, be sure to have the interior of the projector
1
Warning, Notices and Safety Instructions
To Next Page
Loading...
