46
Control
IR Address
Use this function to configure the projector's IR code receive commands from the remote
control. The default value is 1.If you have other equipment in your home that could pick up
the command from the projector's remote control, it is recommended that you set the remote
control code to 2.
When you are running two projectors via serial connection, you can set the code on one
projector as "1" and "2" for the other projector. By doing so, you will be able to control two
projectors with the same remote control.
When you want to switch your remote control from code 1 projector to code 2 projector,
press and hold the ENTER and ADDRESS buttons on the remote control simultaneously (for
approximately 5 seconds); the backlight module on the remote control will blink to confirm the
switch.
Eco Network Power
The projector can be connected to a network via its RS-232 port and 10/100 BASE-T port
for remote operation with two separate boards to control the signal sources from RS-232 and
10/100BASE-T ports.
If you do not require remote operation of the projector over a network, it is recommended that
you set this function to On to activate the ECO Network Power. This will turn off the power
that is used to control the 10/100 BASE-T board. However, you will not be able to operate the
projector remotely over a network as long as the function remains activated.
By setting it to Off, the function will be disabled. You won't be able to conserve power but you
can control the projector remotely over a network.
6
OSD Menu description
To Next Page
Loading...
