AW00097603000 Standard Features
Basler aviator GigE 197
This ability can be useful in two situations:
If you simply want to see how the parameters currently stored in one of the sequence sets will
affect camera operation, you can load the parameters from that sequence set into the active
parameter set and see what happens.
If you want to prepare a new sequence set and you know that an existing set is already close
to what you will need, you can load the existing sequence set into the active set, make some
small changes to the active set, and then save the active set as a new sequence set.
Make sure the sequencer feature is disabled before issuing the Sequence Set Load command.
The following code snippet illustrates using the API to load the sequence parameter values from
sequence set 0 into the active set:
// Select sequence set with index number 0
Camera.SequenceSetIndex.SetValue( 0 );
// Load the sequence parameter values from the sequence set into the
active set
Camera.SequenceSetLoad.Execute( );
You can also use the Basler pylon Viewer application to easily set the parameters.
Replacing the sequence parameter values in the active set via the Sequence Set
Load command is associated with a delay between sending the software
command and it becoming effective. The delay will depend on the specific
installation and the current load on the network. Accordingly, the number of image
acquisitions that may occur between sending the command and it becoming
effective can not be predicted. The Sequence Set Load command is therefore not
suitable for real-time applications, it may, however, be useful for testing purposes.
To Next Page
Loading...
Need help?
General
