Basler GigE CAMERAS - PLC Power and I;O Cable

Physical Interface AW00097603000
36 Basler aviator GigE
5.4.3 PLC Power and I/O Cable
As with the standard power and I/O cable described in the previous section, the PLC power and
I/O cable is a single cable that both connects power to the camera and connects to the camera’s
I/O lines. The PLC power and I/O cable adjusts the voltage levels of PLC devices to the voltage
levels required by the camera and it protects the camera against negative voltage and reverse
polarity.
Close proximity to strong magnetic fields should be avoided.
Basler offers PLC power and I/O cables in several lengths. Each cable is terminated with a 12-pin
Hirose plug (HR10A-10P-12S) on the end that connects to the camera. The other end is
unterminated. Contact your Basler sales representative to order the cable.
For more information about applicable voltage levels, see Section 5.7.1 on page 38.
We recommend using a PLC power and I/O cable if the camera is connected
to a PLC device.
If power for the I/O input is supplied at 24 VDC, you can use a PLC power and
I/O cable when the camera is not connected to a PLC device.