AW00097603000 Standard Features
Basler aviator GigE 257
10.19.2 Saving User Sets
You can save the current parameter set being used by the camera (i.e., the "active" set in the
camera’s volatile memory) to user set 1, user set 2, or user set 3. The user sets are stored in the
camera’s non-volatile memory and will be retained when the camera power is switched off or the
camera is reset. When you save the active set to a user set, any parameter data already in that user
set will be overwritten.
Using Basler pylon to save the current active set to a user set in the camera’s non-volatile memory
is a several step process:
Make changes to the camera’s settings until the camera is operating in a manner that you
would like to save.
Set the User Set Selector to User Set 1, User Set 2, or User Set 3 as desired.
Execute a User Set Save command to save the active set to the selected user set.
Saving an active set to a user set in the camera’s non-volatile memory will overwrite any parameters
that were previously saved in that user set.
You can use the pylon API to set the User Set Selector and to execute the User Set Save command
from within your application software. The following code snippet illustrates using the API to set the
selector and execute the command:
Camera.UserSetSelector.SetValue( UserSetSelector_UserSet1 );
Camera.UserSetSave.Execute( );
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about the pylon API and the pylon Viewer, see Section 3 on page 21.
To Next Page
Loading...
Need help?
General
