AW00097603000 Physical Interface
Basler aviator GigE 37
5.5 Camera Power
Camera power must be supplied to the 12-pin connector on the camera via a cable from your power
supply. Nominal operating voltage is +12 VDC (± 10%) with less than one percent ripple. Power
consumption is as shown in the specification tables in Section 1 of this manual.
Close proximity to strong magnetic fields should be avoided.
5.6 Ethernet GigE Device Information
The camera uses a standard Ethernet GigE transceiver. The transceiver is fully 100/1000 Base-T
802.3 compliant.
NOTICE
Applying incorrect power can damage the camera.
1. The camera’s nominal operating voltage is +12 VDC (± 10 %). If the voltage applied to the
camera is greater than +13.2 VDC, severe damage to the camera can result. If the voltage is
less than +10.8 VDC, the camera may operate erratically.
2. Make sure that the polarity of the power applied to the camera is correct. Applying power with
the wrong polarity can result in severe damage to the camera.
NOTICE
An incorrect plug can damage the camera’s 12-pin connector.
The plug on the cable that you attach to the camera’s 12-pin connector must have 12 female pins.
Using a plug designed for a smaller or a larger number of pins can damage the connector.
To Next Page
Loading...
