Basler GigE CAMERAS - Assigning an Input Line to Receive a Hardware Trigger Signal

Physical Interface AW00097603000
40 Basler aviator GigE
5.7.3 Assigning an Input Line to Receive a Hardware
Trigger Signal
You can assign input line 1 or input line 2 to receive a hardware trigger signal for the following
functions:
 the acquisition start trigger
 the frame start trigger
 the frame counter reset
 the trigger input counter reset
Note that when an input line has been selected as the source signal for a camera function, you must
apply an electrical signal to the input line that is appropriately timed for the function.
For more information about assigning input line 1 or input line 2 to receive a hardware trigger signal,
see Section 6.1 on page 45.