AW00097603000 Image Acquisition Control
Basler aviator GigE 75
7.4 The Frame Start Trigger
The frame start trigger is used to begin frame acquisition. Assuming that the camera is in a "waiting
for frame start trigger" acquisition status, it will begin a frame acquisition each time it receives a
frame start trigger signal.
Note that in order for the camera to be in a "waiting for frame start trigger" acquisition status:
The Acquisition Mode parameter must be set correctly.
A proper Acquisition Start command must be applied to the camera.
A proper acquisition start trigger signal must be applied to the camera (if the Trigger Mode
parameter for the acquisition start trigger is set to on).
For more information about the Acquisition Mode parameter and about Acquisition Start and
Acquisition Stop commands, see Section 7.1 on page 59 and Section 7.2 on page 64.
For more information about the acquisition start trigger, and about the acquisition status, see
Section 7.1 on page 59 and Section 7.3 on page 66.
Referring to the use case diagrams that appear in Section 7.6 on page 87 can help you understand
the explanations of the frame start trigger.
To Next Page
Loading...
Need help?
General
