AW00097603000 Specifications, Requirements, and Precautions
Basler aviator GigE 7
1.4 Mechanical Specifications
The camera housing conforms to protection class IP30 assuming that the lens mount is covered by
a lens or by the cap that is shipped with the camera.
1.4.1 Camera Dimensions and Mounting Points
The cameras are manufactured with high precision. Planar, parallel, and angular sides guarantee
precise mounting with high repeatability.
The camera’s dimensions in millimeters are as shown in the drawings in Figure 3 on page 8.
Camera housings are equipped with four mounting holes on the front and two mounting holes on
each side as shown in the drawings.
To Next Page
Loading...
