Basler GigE CAMERAS - 6 I;O Control; 6.1 Configuring the Input Lines

AW00097603000 Physical Interface
Basler aviator GigE 35
For more information about applicable voltage levels, see Section 5.7.1 on page 38.
NOTICE
An incorrect plug can damage the 12-pin connector.
The plug on the cable that you attach to the camera’s 12-pin connector must have 12 female pins.
Using a plug designed for a smaller or a larger number of pins can damage the
connector.
To avoid a voltage drop with long power wires, we recommend that you supply
camera power VCC through two separate wires between the power supply
and the camera as shown in the figure above.
We also recommend that you supply camera power ground through two
separate wires between the power supply and the camera as shown in the
figure.
Cam Pwr Gnd
Cam Pwr Gnd
I/O In 1
I/O In 2
I/O In Gnd
I/O Out 1
I/O Out 2
I/O Out 3
I/O Out 4
I/O Out VCC
Cam Pwr VCC
Cam Pwr VCC
1
2
3
4
7
8
5
6
11
12
9
10
DC
Power
Supply
Standard Power
and I/O Cable
Hirose
HR10A-10P-12S
12-pin Plug
Fig. 11: Standard Power and I/O Cable
AC In