AW00097603000 Basler Network Drivers and Parameters
Basler aviator GigE 289
Maximum Number Resend Requests - The Maximum Number Resend Requests parameter sets
the maximum number of resend requests the performance driver will send to the camera for each
missing packet.
Resend Timeout - The Resend Timeout parameter defines how long (in milliseconds) the
performance driver will wait after detecting that a packet is missing before sending a resend request
to the camera. The parameter applies only once to each missing packet after the packet was
detected as missing.
Resend Request Response Timeout - The Resend Request Response Timeout parameter
defines how long (in milliseconds) the performance driver will wait after sending a resend request
to the camera before considering the resend request as lost.
If a resend request for a missing packet is considered lost and if the maximum number of resend
requests as set by the Maximum Number Resend Requests parameter has not yet been reached,
another resend request will be sent. In this case, the parameter defines the time separation
between consecutive resend requests for a missing packet.
Packet Timeout - The Packet Timeout parameter defines how long (in milliseconds) the
performance driver will wait for the next expected packet before it sends a resend request to the
camera. This parameter ensures that resend requests are sent for missing packets near to the end
of a frame. In the event of a major interruption in the stream of packets, the parameter will also
ensure that resend requests are sent for missing packets that were detected to be missing
immediately before the interruption. Make sure the Packet Timeout parameter is set to a longer time
interval than the time interval set for the inter-packet delay.
To Next Page
Loading...
Need help?
General
