Basler scout GigE User Manual

Revision History AW00011916000
356 Basler scout GigE
AW00011916000 14 Dec 2012 Indicated Basler AG as bearer of the copyright on the second page.
Added information about the 90° head housing model for the scA1600-
28gm/gc in Section 1.2 on page 2 and Section 1.5.2.2 on page 31.
Removed abs. max. voltages from Section 1.2 on page 2, Section 1.9 on
page 37, Section 7.5 on page 82, and Section 7.7 on page 84.
Updated the upper limit for transmission in the IR cut filter
recommendations in Section 1.4 on page 18.
Added references to Section 12.19 on page 325 in sections 2,10.3.3,
10.3.4, and 12.5.
Added AC In lines and Gnd to the power supply and cable shield in Fig 38
in Section 7.4.2 on page 79.
Replaced max. input voltage by voltage range in Figure 39 in
Section 7.7.1.2 on page 86.
Added a current limiter to Figure 39 and a transistor to Figure 40 in
Section 7.7 on page 84.
Added inversion of the input lines in Section 8.1.3 on page 92.
Removed all text referring to overlapped exposure from Section 9.11.4 on
page 159.
Addded the "Color Creation and Enhancement" Section 10 on page 175.
Transferred the following sections to Section 10 on page 175:
 The Bayer Color Filter
 White Balance
 Integrated IR Cut Filter
 Gamma
Included white balance reset in Section 10.3.1 on page 181.
Included sRGB gamma correction in Section 10.3.2 on page 183.
Included the RGB 8 Packed pixel data format with information wherever
applicable in the manual, particularly in Section 11.1 on page 197 and
Section 11.3.5 on page 213.
Added the "Sequencer" Section 12.5 on page 241.
Added a note that auto functions will not work when the sequencer is
enabled in Section 12.9 on page 287.
Added the " Minimum Output Pulse Width" Section 12.12 on page 304.
Added the "Camera Events" Section 9.11.6 on page 164.
Updated the exposure start delay value for the scA1600-28gm/gc in
Section 9.12 on page 165.
Added the AcquisitionStartEventData and FrameStartEventData events in
Section 12.15 on page 310.
Added the sensor board temperature device information parameter in
Section 12.17 on page 317.
Added the color factory setup in Section 12.18 on page 319.
Added the "Camera Feature Set" section 12.19 on page 325.
Corrected the method used for calculating the CRC checksum to
"X-modem" in Section 13.7 on page 340.
Added Section 13.8 on page 342 describing the sequence set index chunk
and modified Section 13.2 on page 328 accordingly.
Doc. ID Number Date Changes

Basler scout GigE Specifications

General

Brand	Basler
Model	scout GigE
Category	IP Camera
Language	English