AW00011916000 Specifications, Requirements, and Precautions
Basler scout GigE 37
1.9 Precautions
For more specific information about the lens thread length, see Section 1.5.3 on page 32.
Avoid Dust on the Sensor
The camera is shipped with a cap on the lens mount. To avoid collecting dust
on the camera’s IR cut filter (color cameras) or sensor (mono cameras), make
sure that you always put the cap in place when there is no lens mounted on
the camera.
To further enhance dust protection, the internal space in the camera that
contains the imaging sensor is sealed off from the camera’s other internal
spaces.
CAUTION
Lens Thread Length is Limited
Color models of the camera with a C-mount lens adapter are equipped with an
IR cut filter mounted inside of the adapter. The location of this filter limits the
length of the threads on any lens you use with the camera. If a lens with a very
long thread length is used, the IR cut filter will be damaged or destroyed and
the camera will no longer operate.
CAUTION
Voltage Outside of Specified Range Can Cause Damage
The recommended operating voltage of the power to the camera is +12 VDC
(-5 %) to +24 VDC (+5 %). If the voltage is less than +11.3 VDC, the camera
may operate erratically
CAUTION
An Incorrect Plug Can Damage the 12-pin Connector
The plug on the cable that you attach to the camera’s 12-pin connector must
have 12 pins. Use of a smaller plug, such as one with 10 pins or 8 pins, can
damage the pins in the camera’s 12-pin connector.
CAUTION
To Next Page
Loading...
