Physical Interface AW00011916000
88 Basler scout GigE
By default, the camera’s trigger ready (TrigRdy) is assigned to Output Line 2. The trigger ready
signal goes high to indicate the earliest point at which exposure start for the next frame can be
triggered.
The assignment of camera output signals to physical output lines can be changed by the user.
For more information about output line pin assignments and pin numbering, see Section 7.2 on
page 76.
For more information about the exposure active signal, see Section Section 9.11.1 on page 156.
For more information about the trigger ready signal, see Section Section 9.11.3 on page 157 and
Section 9.11.4 on page 159.
For more information about assigning camera output signals to physical output lines, see
Section 8.2.1 on page 93.
To Next Page
Loading...
