Draining the oil
Unit is at operating temperature.
Suitable container is available for collecting the oil.
Fig. 22 Draining the oil
1 Oil filler spigot 2 Oil drain cock
1.
Open oil filler spigot.
2.
Open the oil drain cock and collect the oil in a suitable container.
If the red plastic handle of the oil drain cock is damaged or lost, the cock can be
opened using the cover cap.
For this purpose, unscrew the cover cap, turn it 90° upwards, place it on the cock
and open it.
3.
Close oil drain cock.
4.
Use a suitable wrench to unscrew the oil level gauge.
5.
Clean the inner side (prism) of the oil level gauge.
6.
Check sealing ring and replace if necessary.
7.
Screw in the oil level gauge with a torque of 10 Nm.
9 | Maintenance OPERATING MANUAL
92/150
A_002_en
28.08.2019
To Next Page
Loading...
