What to do if my Bauer POSEIDON PE 200-TB's control system does not switch off?
If the control system of your Bauer Air Compressor does not switch off and the final pressure safety valve blows, it could be because the final pressure monitor is set too high or the final pressure safety valve is defective. Rectify the setting and replace the safety valve.
General| Brand | Bauer |
|---|---|
| Model | POSEIDON PE 200-TB |
| Category | Air Compressor |
| Language | English |
Defines the correct application and intended use of the compressor unit.
Lists improper uses and the manufacturer's liability exclusion.
Fundamental safety information, risks of electric current, and pneumatic dangers.
Guidance for behavior during faults and emergencies, including shutdown.
Detailed technical specifications for PE 200-TB, PE 200-TE, PE 250-TB, PE 250-TE, PE 300-TB, PE 300-TE.
Technical specifications for the IK120 compressor block.
Technical data for filter systems P21, P31, and P41, including pressure and content limits.
Requirements for installation location, surface conditions, and adequate space.
Safety and procedural steps for installing the compressor unit correctly.
Checks before commissioning and procedures for starting up the unit.
General operation procedures, including switching on/off and monitoring.
Guide to identifying and rectifying common faults in the drive motor, compressor block, and systems.
Procedures for checking oil level, oil changes, and venting the oil pump.
General advice, load cycle checks, and procedures for filter system maintenance.
To Next Page
